Powertap P2 - half wattage #644
-
|
Hi, I've seen some variants of this discussion on here already (#70, #71 , #139 ) but didn't quite see a solution that I've gotten to work yet. I have some Powertap P2 pedals which output separately via BT, and each side seems to output half the total watts. However, in the SmartSpin app, I can only seem to pick one pedal which may be expected. What's the most correct/idiomatic way I should solve this issue on my side? I don't care for perfect accuracy so I figure I could maybe just do a power factor of 2x or similar in the config, but if there's a way to actually read from both pedals that would be neat as well. Thanks in advance! |
Beta Was this translation helpful? Give feedback.
Replies: 2 comments 1 reply
-
|
According to DC Rainmaker ( https://www.dcrainmaker.com/2019/03/powertap-pedals-review.html )yes, it sounds like it's a limitation of the pedals. Instead of removing one battery, set 2x and you're good to go. |
Beta Was this translation helpful? Give feedback.
-
|
Thanks for the quick reply! I will do that. Just for completeness' sake, it's this setting? And I should set it to 2x as opposed to 0.5? 
|
Beta Was this translation helpful? Give feedback.
-
|
Yep! Set it to 2.0. |
Beta Was this translation helpful? Give feedback.
According to DC Rainmaker ( https://www.dcrainmaker.com/2019/03/powertap-pedals-review.html )yes, it sounds like it's a limitation of the pedals. Instead of removing one battery, set 2x and you're good to go.